DM505LRBABF datasheet(75/295 Pages) TI2

75 / 295 page

DM505

www.ti.com

SPRS976E – NOVEMBER 2016 – REVISED MAY 2018

Submit Documentation Feedback

Terminal Configuration and Functions

4.5

Connections for Unused Pins

This section describes the connection requirements of the unused and reserved balls.

NOTE

The following balls are reserved: A2 / F6 / A21 / B1

These balls must be left unconnected.

NOTE

All unused power supply balls must be supplied with the voltages specified in the

Section 5.4, Recommended Operating Conditions, unless alternative tie-off options are

included in Section 4.3, Signal Descriptions.

Table 4-29. Unused Balls Specific Connection Requirements

Balls

Connection Requirements

B21 / E22 / J5 / AA10 / AA5 / AA20 / W1 / T21

These balls must be connected to GND through an external pull

resistor if unused

J2 / G5 / G4 / L3 / L4 / AB10 / J3 / AB5 / Y20 / W2 / T22 / L6 / L5

These balls must be connected to the corresponding power supply

through an external pull resistor if unused

M19 / M20 / M21 / M22 / N22 / N21 / P19 / P18 / P20

These balls must be connected together to GND through a single

external 10k-ohm resistor if unused.

NOTE

All other unused signal balls with a Pad Configuration Register can be left unconnected with

their internal pullup or pulldown resistor enabled.

NOTE

All other unused signal balls without Pad Configuration Register can be left unconnected.

DM505LRBABF Datasheet(PDF) 75 Page - Texas Instruments