7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INITIAL BATTERY CHARGING

1. Charge your jump-start battery before using it for the first time.

2. Recharge the jump-start battery after every occasion of use if possible,

and thereafter, at least every 90 days.

3. Always avoid leaving your jump-start in a discharged state.

FOLLOW THE ABOVE POINTS TO ENSURE MAXIMUM LIFE FROM THE BATTERY.

Two means of charging the battery are provided:

1. Via a 230V mains electricity

supply, using the mains adaptor,

as shown.

2. Via a 12V supply using the vehicle

cigar lighter adapter with cable

and plug provided.

NOTE: Using a 12V vehicle supply,

the battery will not charge to

maximum, but only to

approx. 50% of its capacity.

NOTE: A 5 amp fuse is fitted into the cigarette lighter plug adaptor,

accessed by unscrewing the end cap of the adaptor. Take care

not to loose the spring when unscrewing this cap.

CHARGING USING THE 230V MAINS ADAPTOR

1. Plug the cable into the socket at

the rear of the charger, then plug

the adaptor into the mains supply

and switch on.

• The RED/YELLOW/GREEN

CHARGING lights on the jump-

start will light in sequence to

indicate that charging is in

progress.

2. Continue to charge until only the

GREEN light is on to indicate the unit is charged.

3. This could take many hours, dependant upon the state of charge of the

battery.