11

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

USING THE COMPRESSOR (MODEL 1100C ONLY)

For inflating tyres, attach the air hose to the tyre by pushing the connector

down firmly on the tyre adapter and locking in place by turning the connector

locking lever through 90 degrees.

Switch on the compressor. The gauge will indicate the air pressure in the tyre.

Pull out the hose and use one of the

adaptors to connect to the

accessory being inflated.

• Three adapters are provided

which allow the compressor to

be used for inflating air beds,

footballs etc.

Select the appropriate adapter and

push the threaded end firmly into the

air hose connector, locking it in place

by turning the connector locking lever through 90 degrees.

Turn on the compressor using the switch and note the pressure displayed on

the gauge. Switch off when the item is fully inflated. Do not exceed the duty

cycle stated in the specification.

WARNING: DO NOT RUN THE COMPRESSOR FOR MORE THAN 10 MINUTES.

ALLOW A 10 MINUTE PERIOD TO ELAPSE BEFORE SWITCHING ON AGAIN.

CAUTION: THE AIR PRESSURE GAUGE ON THIS PRODUCT IS FOR

GUIDANCE ONLY. IT IS IMPORTANT THAT YOU CHECK YOUR TYRE

PRESSURE WITH A PRESSURE CERTIFIED GAUGE.