HD6432351 datasheet(323/1025 Pages) RENESAS

323 / 1025 page

Section 7 DMA Controller (DMAC)

Rev. 3.00 Sep 15, 2006 page 289 of 988

REJ09B0330-0300

Activation Source Acceptance

At the start of activation source acceptance, a low level is detected in both

DREQ pin falling edge

sensing and low level sensing. Similarly, in the case of an internal interrupt, the interrupt request is

detected. Therefore, a request is accepted from an internal interrupt or

DREQ pin low level that

occurs before execution of the DMABCRL write to enable transfer.

When the DMAC is activated, take any necessary steps to prevent an internal interrupt or

DREQ

pin low level remaining from the end of the previous transfer, etc.

Internal Interrupt after End of Transfer

When the DTE bit is cleared to 0 by the end of transfer or an abort, the selected internal interrupt

request will be sent to the CPU or DTC even if DTA is set to 1.

Also, if internal DMAC activation has already been initiated when operation is aborted, the

transfer is executed but flag clearing is not performed for the selected internal interrupt even if

DTA is set to 1.

An internal interrupt request following the end of transfer or an abort should be handled by the

CPU as necessary.

Channel Re-Setting

To reactivate a number of channels when multiple channels are enabled, use exclusive handling of

transfer end interrupts, and perform DMABCR control bit operations exclusively.

Note, in particular, that in cases where multiple interrupts are generated between reading and

writing of DMABCR, and a DMABCR operation is performed during new interrupt handling, the

DMABCR write data in the original interrupt handling routine will be incorrect, and the write may

invalidate the results of the operations by the multiple interrupts. Ensure that overlapping

DMABCR operations are not performed by multiple interrupts, and that there is no separation

between read and write operations by the use of a bit-manipulation instruction.

Also, when the DTE and DTME bits are cleared by the DMAC or are written with 0, they must

first be read while cleared to 0 before the CPU can write a 1 to them.

HD6432351 Datasheet(PDF) 323 Page - Renesas Technology Corp