HD6432351 datasheet(325/1025 Pages) RENESAS

325 / 1025 page

Section 8 Data Transfer Controller (DTC)

Rev. 3.00 Sep 15, 2006 page 291 of 988

REJ09B0330-0300

Section 8 Data Transfer Controller (DTC)

8.1

Overview

The H8S/2350 Group includes a data transfer controller (DTC). The DTC can be activated by an

interrupt or software, to transfer data.

8.1.1

Features

The features of the DTC are:

• Transfer possible over any number of channels

 Transfer information is stored in memory

 One activation source can trigger a number of data transfers (chain transfer)

• Wide range of transfer modes

 Normal, repeat, and block transfer modes available

 Incrementing, decrementing, and fixing of source and destination addresses can be selected

• Direct specification of 16-Mbyte address space possible

 24-bit transfer source and destination addresses can be specified

• Transfer can be set in byte or word units

• A CPU interrupt can be requested for the interrupt that activated the DTC

 An interrupt request can be issued to the CPU after one data transfer ends

 An interrupt request can be issued to the CPU after the specified data transfers have

completely ended

• Activation by software is possible

• Module stop mode can be set

 The initial setting enables DTC registers to be accessed. DTC operation is halted by setting

module stop mode.

HD6432351 Datasheet(PDF) 325 Page - Renesas Technology Corp