HD6432142 datasheet(438/1177 Pages) RENESAS

438 / 1177 page

Section 13 Timer Connection

Rev. 4.00 Sep 27, 2006 page 394 of 1130

REJ09B0327-0400

IHI signal

CL1 signal

CL2 signal

TCNT

TCORA

Figure 13.3 Timing Chart for Clamp Waveform Generation (CL1 and CL2 Signals)

IHI signal

CL3 signal

TCNT

TICR+TCORC

TICR

Figure 13.4 Timing Chart for Clamp Waveform Generation (CL3 Signal)

13.3.3

Measurement of 8-Bit Timer Divided Waveform Period

The timer connection facility, TMR1, and the free-running timer (FRT) can be used to measure the

period of an IHI signal divided waveform. Since TMR1 can be cleared by a rising edge of inverted

IVI signal, the rise and fall of the IHI signal divided waveform can be virtually synchronized with

the IVI signal. This enables period measurement to be carried out efficiently.

To measure the period of an IHI signal divided waveform, TCNT in TMR1 is set to count the

external clock (IHI signal) pulses and to be cleared on the rising edge of the external reset signal

(inverted IVI signal). The value to be used as the division factor is written in TCORA, and the

TMO output method is specified by the OS bits in TCSR. Examples of TCR and TCSR settings

are shown in table 13.5, and the timing chart for measurement of the IVI signal and IHI signal

divided waveform periods is shown in figure 13.5. The period of the IHI signal divided waveform

is given by (ICRD(3) – ICRD(2))

× the resolution.

HD6432142 Datasheet(PDF) 438 Page - Renesas Technology Corp