HD6432142 datasheet(541/1177 Pages) RENESAS

541 / 1177 page

Section 16 I

2C Bus Interface [Option]

Rev. 4.00 Sep 27, 2006 page 497 of 1130

REJ09B0327-0400

ICDR is an 8-bit readable/writable register that is used as a transmit data register when

transmitting and a receive data register when receiving. ICDR is divided internally into a shift

written by the CPU, ICDRR is read-only, and ICDRT is write-only. Data transfers among the

three registers are performed automatically in coordination with changes in the bus state, and

affect the status of internal flags such as TDRE and RDRF.

If IIC is in transmit mode and the next data is in ICDRT (the TDRE flag is 0) following

transmission/reception of one frame of data using ICDRS, data is transferred automatically from

ICDRT to ICDRS. If IIC is in receive mode and no previous data remains in ICDRR (the RDRF

flag is 0) following transmission/reception of one frame of data using ICDRS, data is transferred

automatically from ICDRS to ICDRR.

If the number of bits in a frame, excluding the acknowledge bit, is less than 8, transmit data and

receive data are stored differently. Transmit data should be written justified toward the MSB side

when MLS = 0, and toward the LSB side when MLS = 1. Receive data bits read from the LSB

side should be treated as valid when MLS = 0, and bits read from the MSB side when MLS = 1.

ICDR is assigned to the same address as SARX, and can be written and read only when the ICE

bit is set to 1 in ICCR.

The value of ICDR is undefined after a reset.

The TDRE and RDRF flags are set and cleared under the conditions shown below. Setting the

TDRE and RDRF flags affects the status of the interrupt flags.

HD6432142 Datasheet(PDF) 541 Page - Renesas Technology Corp