HD6433636SW datasheet(304/418 Pages) RENESAS

304 / 418 page

290

12.4

Interrupts

When A/D conversion ends (ADSF changes from 1 to 0), bit IRRAD in interrupt request

A/D conversion end interrupts can be enabled or disabled by means of bit IENAD in interrupt

enable register 2 (IENR2).

For further details see 3.3, Interrupts.

12.5

Typical Use

An example of how the A/D converter can be used is given below, using channel 4 (pin AN

4) as

the analog input channel. Figure 12.3 shows the operation timing.

1. Bits CH3 to CH0 of the A/D mode register (AMR) are set to 1000, making pin AN

4 the analog

input channel. A/D interrupts are enabled by setting bit IENAD to 1, and A/D conversion is

started by setting bit ADSF to 1.

2. When A/D conversion is complete, bit IRRAD is set to 1, and the A/D conversion result is

stored in the A/D result register (ADRR). At the same time ADSF is cleared to 0, and the A/D

converter goes to the idle state.

3. Bit IENAD = 1, so an A/D conversion end interrupt is requested.

4. The A/D interrupt handling routine starts.

5. The A/D conversion result is read and processed.

6. The A/D interrupt handling routine ends.

If ADSF is set to 1 again afterward, A/D conversion starts and steps 2 through 6 take place.

Figures 12.4 and 12.5 show flow charts of procedures for using the A/D converter.

HD6433636SW Datasheet(PDF) 304 Page - Renesas Technology Corp