FT232R datasheet(8/43 Pages) FTDI

8 / 43 page

Document No.: FT_000053

FT232R USB UART IC Datasheet Version 2.07

Clearance No.: FTDI# 38

Pin No.

Name

Type

Description

3V3OUT

Output

+3.3V output from integrated LDO regulator. This pin should be decoupled to

ground using a 100nF capacitor. The main use of this pin is to provide the internal

+3.3V supply to the USB transceiver cell and the internal 1.5kΩ pull up resistor on

USBDP. Up to 50mA can be drawn from this pin to power external logic if

required. This pin can also be used to supply the VCCIO pin.

VCC

PWR

+3.3V to +5.25V supply to the device core. (see Note 1)

AGND

PWR

Device analogue ground supply for internal clock multiplier

Table 3.2 Power and Ground Group

Pin No.

Name

Type

Description

8, 24

No internal connection

RESET#

Input

Active low reset pin. This can be used by an external device to reset the

FT232R. If not required can be left unconnected, or pulled up to VCC.

TEST

Input

Puts the device into IC test mode. Must be tied to GND for normal

operation, otherwise the device will appear to fail.

OSCI

Input

Input 12MHz Oscillator Cell. Optional – Can be left unconnected for

normal operation. (see Note 2)

OSCO

Output

Output from 12MHZ Oscillator Cell. Optional – Can be left unconnected

for normal operation if internal Oscillator is used. (see Note 2)

Table 3.3 Miscellaneous Signal Group

Pin No.

Name

Type

Description

TXD

Output

Transmit Asynchronous Data Output.

DTR#

Output

Data Terminal Ready Control Output / Handshake Signal.

RTS#

Output

Request to Send Control Output / Handshake Signal.

RXD

Input

Receiving Asynchronous Data Input.

RI#

Input

Ring Indicator Control Input. When remote wake up is enabled in the

internal EEPROM taking RI# low (20ms active low pulse) can be used to

resume the PC USB host controller from suspend.

DSR#

Input

Data Set Ready Control Input / Handshake Signal.

DCD#

Input

Data Carrier Detect Control Input.

CTS#

Input

Clear To Send Control Input / Handshake Signal.

CBUS4

I/O

Configurable CBUS output only Pin. Function of this pin is configured in

the device internal EEPROM. Factory default configuration is SLEEP#. See

CBUS Signal Options, Table 3.9.

CBUS2

I/O

Configurable CBUS I/O Pin. Function of this pin is configured in the

device internal EEPROM. Factory default configuration is TXDEN. See

CBUS Signal Options, Table 3.9.

FT232R Datasheet(PDF) 8 Page - Future Technology Devices International Ltd.

FT232R Datasheet(HTML) 8 Page - Future Technology Devices International Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

Datasheet Download

Link URL