SIP11203 datasheet(9/18 Pages) VISHAY

9 / 18 page

Document Number: 73868

S11-0975–Rev. C, 16-May-11

www.vishay.com

Vishay Siliconix

SiP11203, SiP11204

This document is subject to change without notice.

THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

• While VL is below the UVLOR threshold, the IC

“swaps” the synchronous rectifier drive paths. This

causes the high-going signal on INB to be applied

to the gate of an n-channel hold-off MOSFET,

which is in parallel with the main OUTA driver. This

MOSFET inverts the signal from INB, which causes

its drain to be pulled towards ground. This holds

OUTA low.

• During the deadtime in which neither INB nor INA is

driven high, the voltage on INA and that on INB will

be equal to the voltage on VIN. Depending upon the

exact value of VIN, this may or may not result in

both OUTA and OUTB being pulled low by their

associated inverter MOSFETs.

• During the next cycle of converter operation, all of

the above applies with the exception that INB is

now driven low, which will cause INA to be driven

high. This will in turn cause the hold-off MOSFET in

parallel with the main OUTB driver to conduct,

thereby holding OUTB low.

In this way, the SiP11203/SiP11204 “swap and invert”

function prevents any unwanted turn-on of the

synchronous rectifiers during start-up. Once VL

reaches 90 % of its final value, the drive path inside the

IC is no longer swapped, and the inverting hold-off

MOSFETs are disabled.

FUNCTIONAL BLOCK DIAGRAM

START-UP DRIVER OPERATION

Assuming that VIN rises with suitable rapidity to a

voltage greater than 5.5 V, the factors controlling the

rate of rise of VL are the external VL bypass capacitor

value and the pre-regulator’s current limit. This gives

the following two equations:

• The time from start-up to

CUVLOR  (4.45 V/35 mA) x CVL, and

• The time from start-up to

UVLOR (4.45 V/35 mA) x CVL.

Once VL has reached 90 % of its final value, the clamp

holding VREF at 0 V is released, allowing the voltage on

the VREF pin to rise at a rate set by the value of the

VREF capacitor. This gives the following equation:

• The time from UVLOR to VREF attaining a voltage of

1.1 V



(1.1 V/410 µA) x C

VREF.

These relationships are shown in Figure 4.

Figure 3. During converter startup, the synchronous MOSFET gate-driver outputs of the SiP11203/SiP11204 are reversed and inverted

to prevent spurious MOSFET switching

Hold-off

MOSFET

Hold-off

MOSFET

SW1 and SW2 are closed at start-up.

SW1 and SW2 open when VL > UVLO R.

SW1

SW2

SIP11203 Datasheet(PDF) 9 Page - Vishay Siliconix

SIP11203 Datasheet(HTML) 9 Page - Vishay Siliconix

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Datasheet Download

Link URL