SDA

SCL

S

P

Start Condition

Stop Condition

SDA

SCL

Data Line

Charge

TSU6111A

SCDS331

– FEBRUARY 2012

www.ti.com

Standard I2C Interface Details

must be connected to a positive supply via a pull-up resistor when connected to the output stages of a device.

Data transfer may be initiated only when the bus is not busy.

on the SDA input/output while the SCL input is high (see Figure 2). After the start condition, the device address

byte is sent, MSB first, including the data direction bit (R/W). This device does not respond to the general call

address. After receiving the valid address byte, the device responds with an ACK, a low on the SDA input/output

during the high of the ACK-related clock pulse.

Figure 2. Definition of Start and Stop Conditions

The data byte follows the address ACK. The R/W bit is kept low for transfer from the master to the slave. The

data byte is followed by an ACK sent from this device. Data is sent only if complete bytes are received and

acknowledged. The output data is valid at time (tpv) after the low-to-high transition of SCL, during the clock cycle

for the ACK.

stable during the high pulse of the clock period, as changes in the data line at this time are interpreted as control

commands (START or STOP, see Figure 3).

Figure 3. Bit Transfer

A Stop condition, a low-to-high transition on the SDA input/output while the SCL input is high, is sent by the

master (see Figure 2).

The number of data bytes transferred between the start and the stop conditions from transmitter to receiver is not

limited. Each byte of eight bits is followed by one ACK bit. The transmitter must release the SDA line before the

receiver can send an ACK bit.

A slave receiver address must generate an ACK after the reception of each byte. The device that acknowledges

has to pull down the SDA line during the ACK clock pulse so that the SDA line is stable low during the high pulse

of the ACK-related clock period (see Figure 4). Setup and hold times must be taken into account.

12

Submit Documentation Feedback

Copyright

© 2012, Texas Instruments Incorporated

Product Folder Link(s): TSU6111A