2557

PROTECTED QUAD LOW-SIDE DRIVER

WITH FAULT DETECTION & SLEEP MODE

The A2557xB, A2557xEB, and A2557xLB have been specifically

designed to provide cost-effective solutions to relay-driving applications with

up to 300 mA drive current per channel. They may also be used for driving

incandescent lamps in applications where turn-on time is not a concern. Each

of the four outputs will sink 300 mA in the on state. The outputs have a

minimum breakdown voltage of 60 V and a sustaining voltage of 40 V. A

low-power Sleep Mode is activated with either ENABLE low or all inputs

low. In this mode, the supply current drops to below 100

µA.

Over-current protection for each channel has been designed into these

devices and is activated at a nominal 500 mA. It protects each output from

short circuits with supply voltages up to 32 V. When an output experiences a

short circuit, the output current is limited at the 500 mA current clamp. In

addition, foldback circuitry decreases the current limit if an excessive voltage

is present across the output and assists in keeping the device within its SOA

(safe operating area). An exclusive-OR circuit compares the input and output

state of each driver. If either a short or open load condition is detected, a

single FAULT output is turned on (active low). Similar devices, for operation

to 1.3 A, are available as the UDx2547B/EB.

Continuous or multiple overload conditions causing the channel tempera-

ture to reach approximately 165

°C will result in an additional linear decrease

in the output current of the affected driver. If the fault condition is corrected,

the output stage will return to its normal saturated condition.

The first character of the part number suffix determines the device

operating temperature range. Suffix ‘S-’ is the standard -20

°C to +85°C;

suffix ‘E-’ is -40

°C to +85°C; suffix ‘K-’ is for the industrial temperature

range of -40

°C to +125°C. Package suffix ‘-B’ devices are 16-pin power

DIPs; suffix ‘-EB’ devices are 28-lead power PLCCs; and suffix ‘-LB’ are 16-

lead power wide-body SOICs for surface-mount applications. All packages

are of batwing construction to provide for maximum package power dissipa-

tion.

FEATURES

1

2

3

14

4

5

6

7

8

9

10

11

12

13

15

16

ENABLE

GROUND

GROUND

OUT

3

FAULT

GROUND

GROUND

K

V

CC

Dwg. PP-017-4

A2557xLB

Note that the A2557xB (DIP) and the A2557xLB

(SOIC) are electrically identical and share a

common terminal number assignment.

ABSOLUTE MAXIMUM RATINGS

Over-Current Protected Output Voltage,

Package Power Dissipation,

Suffix ‘S-’ ...................... -20

Suffix ‘E-’ ...................... -40

Suffix ‘K-’ ................... -40

Junction Temperature,

Storage Temperature Range,

*Outputs are current limited at approximately

500 mA per driver and junction temperature

limited if higher current is attempted.

Complete part number includes a suffix to identify operating temperature

range (E-, K-, or S-) and package type (-B, -EB, or -LB). Always order by

complete part number, e.g., A2557KLB .