Automatic serial number generation in the MCU

AN2614

10/12

3.3

Automatic programming

Once the project is fully configured, the programming can be started by clicking on ‘all tabs’

in the ‘program’ menu or on the icon in Figure 3 below.

Figure 3.

Starting the program

The list of actions enabled in the ‘properties’ window is then executed by STVP7, including

the serial numbering.

After each programming sequence, the serial number is updated according to the ‘serial

numbering’ window settings.

If the ‘prompt for new programming cycle’ box was checked under the ‘properties’ window, a

dialog box automatically appears to start the next programming cycle.