RF430CL330HCPWR datasheet(12/47 Pages) TI1

12 / 47 page

I C or SPI

Interface

Processing

Unit

(MSP430-

based)

ISO14443B

Interface

NDEF

Memory

(SRAM)

SCL/SO

SDA/SI

SCK

INTO

ANT1

VCC

VSS

VCORE

ANT2

SCMS/CS

RST

RF430CL330H

SLAS916C – NOVEMBER 2012 – REVISED NOVEMBER 2014

www.ti.com

Detailed Description

5.1

Functional Block Diagram

Figure 5-1 shows the functional block diagram.

Figure 5-1. Functional Block Diagram

5.2

Serial Communication Interface

A "dual-mode" serial communication interface supports either SPI or I2C communication. The serial

interface allows writing and reading the internal NDEF memory as well as configuring the device

operation.

5.3

SPI or I

2C Mode Selection

The selection between I2C or SPI mode takes place during the power-up and initialization phase of the

device based on the input level at pin SCMS/CS (see Table 5-1).

Table 5-1. SPI or I2C Mode Selection

Input Level at SCMS/CS During

Selected Serial Interface

Initialization

I2C

SPI

During initialization, an integrated pullup resistor pulls SCMS/CS high, which makes SPI the default

interface. To enable I2C, this pin must be tied low externally. The pullup resistor is disabled after

initialization to avoid any current through the resistor during normal operation. In SPI mode, the pin reverts

to its CS functionality after initialization.

Detailed Description

Submit Documentation Feedback

Product Folder Links: RF430CL330H

RF430CL330HCPWR Datasheet(PDF) 12 Page - Texas Instruments

RF430CL330HCPWR Datasheet(HTML) 12 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Datasheet Download

Link URL