ST72325AR7-Auto datasheet(132/243 Pages) STMICROELECTRONICS

132 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

Serial peripheral interface (SPI)

ST72325xxx-Auto

132/243

Doc ID 13770 Rev 3

14.5

Error flags

14.5.1

Master mode fault (MODF)

Master mode fault occurs when the master device has its SS pin pulled low.

When a Master mode fault occurs:

●

The MODF bit is set and an SPI interrupt request is generated if the SPIE bit is set.

●

The SPE bit is reset. This blocks all output from the device and disables the SPI

peripheral.

●

The MSTR bit is reset, thus forcing the device into slave mode.

Clearing the MODF bit is done through a software sequence:

A read access to the SPICSR register while the MODF bit is set.

A write to the SPICR register.

Note:

To avoid any conflicts in an application with multiple slaves, the SS pin must be pulled high

during the MODF bit clearing sequence. The SPE and MSTR bits may be restored to their

original state during or after this clearing sequence.

Hardware does not allow the user to set the SPE and MSTR bits while the MODF bit is set

except in the MODF bit clearing sequence.

14.5.2

Overrun condition (OVR)

An overrun condition occurs, when the master device has sent a data byte and the slave

device has not cleared the SPIF bit issued from the previously transmitted byte.

When an Overrun occurs:

●

The OVR bit is set and an interrupt request is generated if the SPIE bit is set.

In this case, the receiver buffer contains the byte sent after the SPIF bit was last cleared. A

read to the SPIDR register returns this byte. All other bytes are lost.

The OVR bit is cleared by reading the SPICSR register.

14.5.3

Write collision error (WCOL)

A write collision occurs when the software tries to write to the SPIDR register while a data

transfer is taking place with an external device. When this happens, the transfer continues

uninterrupted; and the software write will be unsuccessful.

Write collisions can occur both in master and slave mode. See also Slave select

management on page 127.

Note:

A “read collision” will never occur since the received data byte is placed in a buffer in which

access is always synchronous with the MCU operation.

The WCOL bit in the SPICSR register is set if a write collision occurs.

No SPI interrupt is generated when the WCOL bit is set (the WCOL bit is a status flag only).

Clearing the WCOL bit is done through a software sequence (see Figure 62).

ST72325AR7-Auto Datasheet(PDF) 132 Page - STMicroelectronics

ST72325AR7-Auto Datasheet(HTML) 132 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL