ST72325AR7-Auto datasheet(134/243 Pages) STMICROELECTRONICS

134 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

Serial peripheral interface (SPI)

ST72325xxx-Auto

134/243

Doc ID 13770 Rev 3

14.6

Low power modes

14.6.1

Using the SPI to wake up the MCU from Halt mode

In slave configuration, the SPI is able to wake up the ST7 device from Halt mode through a

SPIF interrupt. The data received is subsequently read from the SPIDR register when the

software is running (interrupt vector fetch). If multiple data transfers have been performed

before software clears the SPIF bit, then the OVR bit is set by hardware.

Note:

When waking up from Halt mode, if the SPI remains in Slave mode, it is recommended to

perform an extra communications cycle to bring the SPI from Halt mode state to normal

state. If the SPI exits from Slave mode, it returns to normal state immediately.

Caution:

The SPI can wake up the ST7 from Halt mode only if the Slave Select signal (external SS

pin or the SSI bit in the SPICSR register) is low when the ST7 enters Halt mode. So if Slave

selection is configured as external (see Slave select management on page 127), make sure

the master drives a low level on the SS pin when the slave enters Halt mode.

14.7

Interrupts

Note:

The SPI interrupt events are connected to the same interrupt vector (see Interrupts chapter).

They generate an interrupt if the corresponding Enable Control Bit is set and the interrupt

mask in the CC register is reset (RIM instruction).

Table 65.

Effect of low power modes on SPI

Mode

Effect

Wait

No effect on SPI.

SPI interrupt events cause the device to exit from Wait mode.

Halt

SPI registers are frozen.

In Halt mode, the SPI is inactive. SPI operation resumes when the MCU is woken up by

an interrupt with “exit from Halt mode” capability. The data received is subsequently

read from the SPIDR register when the software is running (interrupt vector fetching). If

several data are received before the wake-up event, then an overrun error is generated.

This error can be detected after the fetch of the interrupt routine that woke up the

device.

Table 66.

SPI interrupt control/wake-up capability

Interrupt event

Event flag

Enable

control bit

Exit from

Wait

Exit from

Halt

SPI End of Transfer event

SPIF

SPIE

Yes

Master Mode Fault event

MODF

Overrun error

OVR

ST72325AR7-Auto Datasheet(PDF) 134 Page - STMicroelectronics

ST72325AR7-Auto Datasheet(HTML) 134 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL