IPAC-X datasheet(39/270 Pages) INFINEON

39 / 270 page

IPAC-X

PSB/PSF 21150

Description of Functional Blocks

Data Sheet

2003-01-30

3.2.2

Parallel Microcontroller Interface

The 8-bit parallel microcontroller interface with address decoding on chip allows easy

and fast microcontroller access.

The parallel interface of the IPAC-X provides three types of

mP buses which are selected

via pin ALE. The bus operation modes with corresponding pins are listed in Table 5.

The occurrence of an edge on ALE, either positive or negative, at any time during the

operation immediately selects the interface type (3). A return to one of the other interface

types is possible only if a hardware reset is issued.

Note: If the multiplexed address/data bus type (3) is selected, the unused address pins

A0-A7 must be tied to VDD.

A read/write access to the IPAC-X registers can be done in multiplexed or non-

multiplexed mode:

• In non-multiplexed mode the register address must be applied to the address bus (A0-

A7) for the data access via the data bus (AD0-AD7).

• In multiplexed mode the address on the address/data bus (AD0-AD7) is latched in by

ALE before a data read/write access via the same bus is performed.

The IPAC-X provides two different ways to address the register contents which is

selected with the AMOD pin (’0’ = direct mode, ’1’ = indirect mode). Figure 10 illustrates

both register addressing modes.

Direct address mode (AMOD = ’0’): The register address to be read or written is directly

set in the way described above.

Indirect address mode (AMOD = ’1’): Only the LSB of the address is used to select

either the address register (A0 = ’0’) or the data register (A0 = ’1’). The microcontroller

writes the register address to the ADDRESS register before it reads/writes data from/to

the corresponding DATA register.

In indirect address mode the IPAC-X evaluates no address line except the least

significant address bit. The remaining address lines must not be left open but have to be

tied to logical ’1’.

Table 5

Bus Operation Modes

Bus Mode

Pin ALE

Control Pins

(1)

Motorola

VDD

CS, R/W, DS

(2)

Siemens/Intel non-multiplexed

VSS

CS, WR, RD

(3)

Siemens/Intel multiplexed

Edge

CS, WR, RD, ALE

IPAC-X Datasheet(PDF) 39 Page - Infineon Technologies AG

IPAC-X Datasheet(HTML) 39 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL