DAC5686IPZP datasheet(27/46 Pages) TI

27 / 46 page

www.ti.com

Interleave Bus Mode

IOUTB1

IOUTB2

IOUTA1

IOUTA2

16-Bit

DAC

2Fdata

2 – 16 y Fdata

Fdata

16-Bit

DAC

2Fdata

FIR1

Edge Triggered

Input Latches

• ••

DA[15:0]

DEMUX

DA[15:0]

ts(DATA)

th(DATA)

TxENABLE

ts(TxENABLE)

CLK1 or

PLLLOCK

DAC5686

SLWS147B – APRIL 2003 – REVISED AUGUST 2004

In interleave bus mode, one parallel data stream with interleaved data (I and Q) is input to the DAC5686 on data

bus DA. Interleave bus mode is selected by setting INTERL to 1 in the config_msb register. Figure 31 shows

the DAC5686 data path in interleave bus mode. The interleave bus mode timing diagram is shown in Figure 32.

Figure 31. Interleave Bus Mode Data Path

Figure 32. Interleave Bus Mode Timing Diagram Using TxENABLE

Interleaved user data on data bus DA is alternately multiplexed to internal data channels A and B. Data channels

A and B can be synchronized using either the QFLAG pin or the TxENABLE pin. When qflag in register

config_usb is 0, transitions on TxENABLE identify the interleaved data sequence. The first data after the rising

edge of TxENABLE is latched with the rising edge of CLK as channel-A data. Data is then alternately distributed

to B and A channels with successive rising edges of CLK. When qflag is 1, the QFLAG pin is used as an output

to identify the interleaved data sequence. QFLAG high identifies data as channel B (see Figure 33).

DAC5686IPZP Datasheet(PDF) 27 Page - Texas Instruments