PPC5605BAMLL4R datasheet(34/114 Pages) NXP

34 / 114 page

MPC5607B Microcontroller Data Sheet, Rev. 10

Electrical characteristics

NXP Semiconductors

3.8

Nexus 2+ pins

In the 208 MAPBGA package, eight additional debug pins are available (see Table 6).

Electrical characteristics

This section contains electrical characteristics of the device as well as temperature and power

considerations.

This product contains devices to protect the inputs against damage due to high static voltages. However,

it is advisable to take precautions to avoid application of any voltage higher than the specified maximum

rated voltages.

To enhance reliability, unused inputs can be driven to an appropriate logic voltage level (VDD or VSS). This

could be done by the internal pull-up and pull-down, which is provided by the product for most general

purpose pins.

7 “Not applicable” because these functions are available only while the device is booting. Refer to the BAM

information for details.

8 Value of PCR.IBE bit must be 0

9 This wakeup input cannot be used to exit STANDBY mode.

10 Out of reset all the functional pins except PC[0:1] and PH[9:10] are available to the user as GPIO.

PC[0:1] are available as JTAG pins (TDI and TDO respectively).

PH[9:10] are available as JTAG pins (TCK and TMS respectively).

It is up to the user to configure these pins as GPIO when needed.

11 PC[1] is a fast/medium pad but is in medium configuration by default. This pad is in Alternate Function 2 mode after

reset which has TDO functionality. The reset value of PCR.OBE is ‘1’, but this setting has no impact as long as this

pad stays in AF2 mode. After configuring this pad as GPIO (PCR.PA = 0), output buffer is enabled as reset value

of PCR.OBE = 1.

12 Not available in 100 LQFP package

Table 6. Nexus 2+ pin descriptions

Port pin

Function

I/O

direction

Pad type

Function

after reset

Pin number

100

LQFP

144

LQFP

208 MAP

BGA1

1 208 MAPBGA available only as development package for Nexus2+

MCKO

Message clock out

—

MDO0

Message data out 0

—

H15

MDO1

Message data out 1

—

H16

MDO2

Message data out 2

—

H14

MDO3

Message data out 3

—

H13

EVTI

Event in

Pull-up

—

EVTO

Event out

—

MSEO

Message start/end out

—

G16

PPC5605BAMLL4R Datasheet(PDF) 34 Page - NXP Semiconductors

PPC5605BAMLL4R Datasheet(HTML) 34 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL