8MCJS505 datasheet(18/42 Pages) SOURIAU

18 / 42 page

microComp® Series

Wiring instructions

Contacts are inserted and extracted from the rear of the

connector

Insertion of the contacts

1 - Engage the crimp cable / contact assembly into the longitudinal

slot of the plastic tool 8MCIET (blue side).

Slide the tool down the cable until the tip of the tool abuts the

contact retention shoulder.

2 - Introduce the contact into the required contact cavity in the

insulator, pushing tool axially, until the contact snaps into position

in clip.

3 - Withdraw the tool (from rear). Check that contact is firmly

locked by pulling wire gently.

When connector is fully loaded, check the position of contact tips.

They should all be in the same plane.

Nota : For cable that is stiff enough, manual insertion without

tool is preferable.

Extraction of the contacts

1 - Engage the appropriate cable into the longitudinal slot of the

tool with the white tip towards connector.

2 - Slide the tool down towards the contact. Insert the tool in the

insulator until it abuts the contact shoulder.

3 - Holding the tool-contact and cable assembly together, remove

them simultaneously.

8MCJS505 Datasheet(PDF) 18 Page - SOURIAU-SUNBANK Connection Technologies