AM69AX datasheet(283/299 Pages) TI

283 / 299 page

MCU_OSPI[x]_CLK

OSPI/QSPI/SPI

Device Clock Input

OSPI/QSPI/SPI

Device IO[y], CS#

MCU_OSPI[x]_D[y],

MCU_OSPI[x]_CSn[z]

MCU_OSPI_Board_01

MCU_OSPI[x]_LBCLKO

MCU_OSPI[x]_DQS

OSPI Device DQS

* 0 Ω resistor (R1), located as close as possible to the MCU_OSPI[x]_CLK pin, is placeholder for fine tuning, if needed.

Figure 11-1. OSPI Interface High Level Schematic

11.2.2 External Board Loopback

• The MCU_OSPI[x]_CLK output signal must be connected to the CLK pin of the flash device

• The MCU_OSPI[x]_LBCLKO output signal must be looped back into the MCU_OSPI[x]_DQS input

• The signal propagation delay from the MCU_OSPI[x]_CLK pin to the flash device CLK input pin (A to B)

should be approximately equal to half of the signal propagation delay from the MCU_OPSI[x]_LBCLKO pin to

the MCU_OSPI[x]_DQS pin ((C to D)/2). See the note below.

• The signal propagation delay from the MCU_OSPI[x]_CLK pin to the flash device CLK input pin (A to B) must

be approximately equal to the signal propagation delay of the control and data signals between the flash

device and the SoC device (E to F, or F to E)

• 50 Ω PCB routing is recommended along with series terminations, as shown in Figure 11-2

• Propagation delays and matching:

– A to B = E to F = (C to D) / 2

– Matching skew: < 60 ps

www.ti.com

AM69A

SPRSP92 – FEBRUARY 2023

Submit Document Feedback

283

Product Folder Links: AM69A

AM69AX Datasheet(PDF) 283 Page - Texas Instruments