HC705RC16GRSSLASHD datasheet(77/120 Pages) NXP

77 / 120 page

Carrier Modulator Transmitter (CMT)

Modulator

MC68HC705RC16 — Rev. 3.0

General Release Specification

Carrier Modulator Transmitter (CMT)

Similarly, to calculate the length of an extended space in FSK mode, use

the equation:

Where:

fcg is the frequency output from the carrier generator. For an

example of extended space operation, see Figure 9-9.

NOTE:

The EXSPC feature can be used to emulate a zero mark event.

Figure 9-9. Extended Space Operation

9.5.3.1 End Of Cycle (EOC) Interrupt

At the end of each cycle (when the counter is reloaded from MBUFF),

the end of cycle (EOC) flag is set. If the interrupt enable bit was

previously set, an interrupt will also be issued to the CPU. The EOC

interrupt provides a means for the user to reload new mark/space values

into the MBUFF and SBUFF registers. As the EOC interrupt is coincident

with reloading the counter, MBUFF does not require additional buffering

and may be updated with a new value for the next period from within the

EOC interrupt service routine (ISR). To allow both mark and space

period values to be updated from within the same ISR, SREG is buffered

by SBUFF. The contents written to SBUFF are transferred to the active

EOC flag. The EOC flag is cleared by a read of the modulator control and

status register (MCSR) followed by an access of MDR2 or MDR3. The

EOC flag must be cleared within the ISR to prevent another interrupt

being generated after exiting the ISR. If the EOC interrupt is not being

used (IE = 0), the EOC flag need not be cleared.

((SBUFF1)+(MBUFF2+1+SBUFF2)+... (MBUFFn+1+SBUFFn))

fcg

texspace =

secs

SET EXSPC

CLEAR EXSPC

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705RC16GRS/D Datasheet(PDF) 77 Page - NXP Semiconductors