E2 Lite

Setup

R20UT3240EJ0300 Rev.3.00

Page 20 of 36

May.15.20

2.3

Connecting the E2 Lite to the User System

Use the procedure below to connect the E2 Lite to the user system with the user-system interface cable, or

to disconnect them when moving the E2 Lite or the user system.

(1) Connect the user-system interface cable to the user-side connector of the E2 Lite.

When connecting the user-system interface cable to the E2 Lite, check the position of the erroneous

insertion prevention key to ensure that the cable is plugged in correctly.

E2 Lite

Figure 2.2 User-Side Connector on the E2 Lite

CAUTION

Notes on connector insertion and removal:

When connecting or disconnecting the user-system interface cable and the emulator, grasp the

connector at the end of the cable. Pulling the cable itself will damage the wiring.

Also, be aware that the user-system interface cable has the direction in which it must be inserted. If

the cable is connected in the wrong direction, it may be damaged.

Correct example

Incorrect example

VCC

RESET

ACT

E2 Lite

USER I/F

User-side connector

GND