E2 Lite

Setup

R20UT3240EJ0300 Rev.3.00

Page 21 of 36

May.15.20

(2) A connector to the user-system interface cable must be installed on the user system. Table 2.1 shows the

recommended connector for the emulator.

Table 2.1 Recommended Connector

Connector

Type Number

Manufacturer

Specifications

14-pin (2.54-mm

pitch) connector

7614-6002

3M Japan Limited

14-pin straight type (Japan)

2514-6002

3M Limited

14-pin straight type (other countries)

20-pin (1.27-mm

pitch) connector

FTSH-110-01-L-DV-K

Samtec

20-pin surface-mount straight type

10-pin (1.27-mm

pitch) connector

FTSH-105-01-L-DV-K

Samtec

10-pin surface-mount straight type

10-pin (1.27-mm

pitch) connector

FTSH-105-01-L-DV*

(no guide marking)

Samtec

10-pin surface-mount straight type

Note: When using the connector without a guide marking, take care regarding the direction for insertion of the cable.

(3) For the pin assignments of the connector, refer to the additional document for user’s manual for the

E1/E20 emulator or E2 emulator Lite which corresponds to the target MCU.

(4) Connect one end of the user-system interface cable to the E2 Lite and the other end to the connector on

the user system as shown in Figure 2.3 and Figure 2.4.

Figure 2.3 Connecting the User-System Interface Cable to the 14-Pin Connector when the E2 Lite is

to be Used

User system

Connector:

20-pin (1.27-mm pin pitch) connector

Samtec type number: FTSH-110-01-L-DV-K

Pin 1

Pin 2

User-system interface cable with the 20-pin

(1.27-mm pin pitch) connector

Figure 2.4 Connecting the User-System Interface Cable to the 20-Pin Connector when the E2 Lite is

to be Used

User system

14-pin user-system interface cable

14-pin connector

7614-6002 or

2514-6002

Pin 1

Pin 2