GS-BT2416C2 datasheet(23/32 Pages) STMICROELECTRONICS

23 / 32 page

GS-BT2416C2.AT1

AT command

23/32

A.20

AT+BTMACROSTART

Set the device in a programmable way. Every AT command coming after, with own

parameters, will not be executed but will be stored in the very insertion order.

This command will be available only if the device is set to COMMAND MODE.

To notice that starting a macro storing sequence will erase any previous present sequence.

Syntax: AT+BTMACROSTART

Return value: <OK, ERROR>

A.21

AT+BTMACROSTOP

Stop the programmable status and store the commands sequence inserted so far into the

flash memory of the module. If the sequence is larger then memory block available an error

will be raised. The command will be available only if a device is set to COMMAND MODE

and only if it come after an AT+BTMACROSTART command.

Due to internal time needed to write a flash memory area a little

time delay is possible before any return value.

Syntax: AT+BTMACROSTOP

Return value: <OK, ERROR>

A.22

AT+BTMACROCLEAR

Erase any possible commands sequence present into the flash memory. This operation is

non-reversible.

Syntax: AT+BTMACROCLEAR

Return value: <OK, ERROR>

GS-BT2416C2 Datasheet(PDF) 23 Page - STMicroelectronics