ST7265X datasheet(24/166 Pages) STMICROELECTRONICS

24 / 166 page

ST7265x

24/166

FLASH PROGRAM MEMORY (Cont’d)

4.6 IAP (In-Application Programming)

This mode uses a BootLoader program previously

stored in Sector 0 by the user (in ICP mode or by

plugging the device in a programming tool).

This mode is fully controlled by user software. This

allows it to be adapted to the user application, (us-

er-defined strategy for entering programming

mode, choice of communications protocol used to

fetch the data to be stored, etc.). For example, it is

possible to download code from the SPI, SCI, USB

or CAN interface and program it in the Flash. IAP

mode can be used to program any of the Flash

sectors except Sector 0, which is write/erase pro-

tected to allow recovery in case errors occur dur-

ing the programming operation.

4.7 Related Documentation

For details on Flash programming and ICC proto-

col, refer to the ST7 Flash Programming Refer-

ence Manual and to the ST7 ICC Protocol Refer-

ence Manual

4.8 Register Description

FLASH CONTROL/STATUS REGISTER (FCSR)

Read /Write

Reset Value: 0000 0000 (00h)

This register is reserved for use by Programming

Tool software. It controls the Flash programming

and erasing operations.

Table 6. FLASH Register Map and Reset Values

000

00000

Address

(Hex.)

Label

54321

002Bh

FCSR

Reset Value

00000

ST7265X Datasheet(PDF) 24 Page - STMicroelectronics