ATtiny261A datasheet(155/292 Pages) ATMEL

155 / 292 page

155

8197A–AVR–10/09

ATtiny261A/461A/861A

• Bit 7:6 – REFS1:REFS0: Voltage Reference Selection Bits

These bits together with the REFS2 bit from the ADC Control and Status Register B (ADCSRB)

select the voltage reference for the ADC, as shown in Table 15-4.

If these bits are changed during a conversion, the change will not go in effect until this conver-

sion is complete (ADIF in ADCSR is set). Also note, that when these bits are changed, the next

conversion will take 25 ADC clock cycles.

Special care should be taken when changing differential channels. Once a differential channel

has been selected the input stage may take a while to stabilize. It is therefore recommended to

force the ADC to perform a long conversion when changing multiplexer or voltage reference set-

tings. This can be done by first turning off the ADC, then changing reference settings and then

turn on the ADC. Alternatively, the first conversion results after changing reference settings

should be discarded.

It is not recommended to use an external AREF higher than (VCC - 1V) for channels with differ-

ential gain, as this will affect ADC accuracy.

Internal voltage reference options may not be used if an external voltage is being applied to the

AREF pin.

• Bit 5 – ADLAR: ADC Left Adjust Result

The ADLAR bit affects the presentation of the ADC conversion result in the ADC Data Register.

Write one to ADLAR to left adjust the result. Otherwise, the result is right adjusted. Changing the

ADLAR bit will affect the ADC Data Register immediately, regardless of any ongoing conver-

sions. For a comple te description of this bit, see “ADCL and ADCH – The ADC Data Register”

on page 154.

• Bits 4:0 – MUX4:0: Analog Channel and Gain Selection Bits

These bits and the MUX5 bit from the ADC Control and Status Register B (ADCSRB) select

which combination of analog inputs are connected to the ADC. In case of differential input, gain

selection is also made with these bits. Selecting the same pin as both inputs to the differential

Table 15-4.

Voltage Reference Selections for ADC

REFS2

REFS1

REFS0

Voltage Reference Selection

VCC used as voltage reference,

disconnected from AREF

External voltage reference at AREF pin,

internal voltage reference turned off

Internal 1.1V voltage reference

Reserved

110

Internal 2.56V voltage reference (

VCC > 3.0V),

without external bypass capacitor,

disconnected from AREF

111

Internal 2.56V voltage reference (

VCC > 3.0V),

with external bypass capacitor at AREF pin

ATtiny261A Datasheet(PDF) 155 Page - ATMEL Corporation

ATtiny261A Datasheet(HTML) 155 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL