TLE6288R

Pin Configuration

Data Sheet

6

Rev. 2.5, 2010-10-11

2.3

Pin Description

17

DOUT5

Drain Output CH 5 (high/low side)

18

SOUT5

Source Output CH 5 (high/low side)

19

SOUT3

Source Output CH 3 (high side)

20

DOUT3

Drain Output CH 3 (high side)

21

VCP

Charge Pump capacitor pin

22

FSIN

All Channels Enable/Disable

23

GND

Logic Ground

24

Fault

General Fault Flag

25

IN3

Control Input Channel 3

26

IN6

Control Input Channel 6

27

Reset

Reset pin (+ Standby Mode)

28

V

CC

Logic Supply Voltage (5 V)

29

V

DO

Supply pin for digital outputs

30

SO

SPI Serial Data Output

31

CLKProg

Program pin of SPI Clock

32

SCLK

SPI Serial Clock

33

CS

SPI Chip Select

34

SI

SPI Serial Data Input

35

DOUT6

Drain Output CH 6 (high/low side)

36

SOUT6

Source Output CH 6 (high/low side)

Symbol

Description

DOUT1-3 Drain of the 3 highside channels. These pins must always be connected to the same power (battery)

supply line (

V

SOUT1-3 Source of the 3 highside channels. Outputs of the highside channels where the load is connected.

DOUT4-6 Drain pins of the 3 configurable channels. In highside configuration they must be connected to the

same voltage as DOUT1-3. In lowside configuration they are the output pins and connected to the

load.

SOUT4-6 Source of the 3 configurable channels. In highside configuration they are the outputs and connected

to the load. In lowside configuration they must be connected with GND.

IN1-6

Parallel input pins for the 6 power outputs. These pins have an internal pull-down structure.

GND

Logic ground pin, the heat slug has to be connected to this potential.

FSIN

Disable pin. If the FSIN pin is in a logic low state, it switches all outputs OFF. The pin has an internal

pull-up structure.

Reset

Reset pin. When the reset is low all channels are off, the internal biasing is deactivated, all internal

registers are cleared and the supply-current consumption is reduced (standby mode). The pin has an

internal pull-up structure.

Fault

General Fault pin. There is a general fault pin (open drain) which shows a high to low transition as

soon as an error is latched into the diagnosis register. When the diagnosis register is cleared this flag

is also reset (high ohmic). This fault indication can be used to generate a

μC interrupt.

Pin

Symbol

Function