WM8912 datasheet(65/128 Pages) WOLFSON

65 / 128 page

Production Data

WM8912

PD, Rev 4.0, September 2010

Figure 44 Clocking Scheme

SYSCLK CONTROL

The SYSCLK_SRC bit is used to select the source for SYSCLK. The source may be either the

selected MCLK source or the FLL output. The MCLK source can be inverted or non-inverted, as

selected by the MCLK_INV bit. The selected source may also be adjusted by the MCLK_DIV divider

to generate SYSCLK. These register fields are described in Table 39. See “Frequency Locked Loop

(FLL)” for more details of the Frequency Locked Loop clock generator.

The SYSCLK signal is enabled by register bit CLK_SYS_ENA. This bit should be set to 0 when

reconfiguring clock sources. It is not recommended to change SYSCLK_SRC while the

CLK_SYS_ENA bit is set.

The following operating frequency limits must be observed when configuring SYSCLK. Failure to

observe these limits will result in degraded noise performance and/or incorrect DAC functionality.



SYSCLK

≥ 3MHz



If DAC_OSR128 = 1 then SYSCLK

≥ 6MHz



If DAC_MONO = 1, then SYSCLK

≥ 64 x fs



If DAC_MONO = 0, then SYSCLK

≥ 128 x fs

Note that DAC Mono mode (DAC_MONO = 1) is only valid when one or other DAC is disabled. If

both DACs are enabled, then the minimum SYSCLK for clocking the DACs is 128 x fs.

WM8912 Datasheet(PDF) 65 Page - Wolfson Microelectronics plc