GMS30004 datasheet(91/158 Pages) HYNIX

91 / 158 page

Timing for setting port input register is :

a) When machine cycle of the file <current machine cycle after executing this

command, values shall be set on the port input register until the machine cycle

of the file> current machine cycle while executing the first G or T command.

b) When machine cycle of the file = current machine cycle, setting is made

immediately before the next command is executed.

In case there is a format error in I/O file while simulating, error message shall be

output and the operation is stopped.

In order to execute G or T command again, this mode has to be canceled first.

(Execute SET PI 0 or SET PI 1.)

Default value here is 0.

All the I/O READ commands are read from the port input register.

PORT.DAT format

Machine cycle I Port Name I Data

(I indicates space or tab)

• SET WD x

0 : Watch dog timer shall not be used.

1 : Watch dog timer shall be used. (No option)

Resetting watch dog timer

1) After executing WDTR command

2) After executing STOP command

3) After executing CR command

4) While converting to 0 with R command

5) When the set value is reached.

2 : Watch dog timer shall be used. (With option)

For resetting watch dog timer.

1) When SO command is executed to REMOUT output is added to the

above 1) ~ 5).

Defalut value here is 0.

Chapter 5. Software

5 - 37

GMS30004 Datasheet(PDF) 91 Page - Hynix Semiconductor