| Electronic Components Datasheet Search |
|
AN3392 Datasheet(PDF) 26 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
AN3392 Datasheet(HTML) 26 Page - STMicroelectronics |
|
26 / 57 page ![]() Pin description AN3392 26/57 Doc ID 018749 Rev 1 8 Pin description Table 3. Pin description Pin (PSSO-36) Name Type Description 34 Vin Supply DC input power 7,8,17,18,19, 20,29,31 VOUT Supply Boost output voltage, pins 7 and 8 are internally shorted and connected to pins 29 and 30. Pins 17 and 18 are internally shorted and connected to pins 19 and 20. All of the VOUT pins must be connected to the VOUT rail of the PCB. 12,13,24,25 PGND Ground Power ground to be connected to the ground plane of the PCB. 1 SGND Ground Signal ground to be connected to the ground plane of the PCB. 10,11,14,15, 22,23,26,27 LX1…4 I Boost inductor connection. 9,16,21,28 CB1…4 I/O External bootstrap capacitors to be connected between these pins and LXi. 31 XCS I Chip select for SPI interface:XCS = HIGH => SPI device is not active XCS = LOW => SPI device is active If this pin is left floating an internal resistor pulls the XCS pin up, switching the SPI off. 32 SPI_DATA_IN I Input pin for SPI data flow. If not used, this pin should be connected to ground. 33 SPI_CLK I Input pin for SPI clock signal. If not used, this pin should be connected to ground. 35 VIN_SNS I Sense pin of input voltage. To be biased with a resistor divider between VIN and SGND. 36 VIN_SNS_M I Dedicated reference pin for voltage sensing. 2PZ_OUT I/O This pin is used to compensate the feedback loop of the output voltage. A series of resistors and capacitors must be connected to SGND. 3VOUT_SNS I Sense pin of output voltage. To be biased with a resistor divider between VOUT and SGND. 4OSC_IN I Pin for adjusting the switching frequency. To set the default value (100 kHz) this pin must be tied to VREG, otherwise for adjustment it must be biased through a resistor to SGND. 5VREG I/O Power supply for internal low-voltage circuitry; an external capacitor must be connected from this pin to the ground plane of the PCB. 6 SPI_DATA_OUT O Output pin for SPI data flow. If not used, this pin should be left floating. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |