UM0991 datasheet(46/52 Pages) STMICROELECTRONICS

46 / 52 page

Building, debugging and running your application with STVD

UM0991

46/52

Doc ID 17891 Rev 2

Building, debugging and running your application

with STVD

Once your have developed your application code, created your workspace environment, and

launched STVD, you can start building, debugging and programming your application for the

target microcontroller.

Note:

This section refers to STVD, if you are using IAR Embedded Workbench, please refer to the

IAR Getting Started documentation.

6.1

Building your application

Once your project is created, the build context is enabled by default. It allows to access all

the commands required to set up, customize, and build your application.

The build configuration is available by selecting Build>Configurations from the STVP main

menu toolbar. It allows you to change the application building settings.

Two preset configurations are available in STVD:

●

Debug

This configuration creates a version of your application that allows using all the STVD

advanced debugging features. When using this configuration, output files are saved in

the Debug directory in your workspace directory.

●

Release

This configuration creates a version of your application that uses the default

optimization for your toolset. This version of your application is ready to be

programmed to your target microcontroller.

Follow the sequence below to build a project:

Ensure that the Debug configuration is selected by clicking Build>Configurations. If

the Debug configuration is not selected, highlight it and click Set Active (see

Figure 40).

Figure 40.

Selecting the project configuration

UM0991 Datasheet(PDF) 46 Page - STMicroelectronics