AN4472 datasheet(4/44 Pages) STMICROELECTRONICS

Part #	AN4472

Description	STEVAL-IME008V1 evaluation board based on the STHV749 transmission pulser

PDF	44 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

4 / 44 page

Getting starting

AN4472

4/44

DocID026198 Rev 1

Getting starting

The STEVAL-IME008V1 is shipped by STMicroelectronics, ready to use in Normal mode.

The user only needs to:

plug the right power supply to the board (see Section 3.1)

connect the BNC to the oscilloscope

check that switch SW1 is set on the FPGA position

check that the LED indicator DONE (D23) turns on

check that FPGA is in the idle state (LED D4 is on)

select the waveform with the Program button – the corresponding program LED (D6-

D21) turns on

press the START button to run the selected program – the START LED (D2) turns on

the selected waveform continuous until the STOP button is pressed, which lights the

relative LED (D3) – when the program ends, the FPGA returns to the idle state (LED

D4 is on)

to run the same program again, restart from step 7; to run another program, restart

from step 6

For Programming mode information, please refer to UM1083.

AN4472 Datasheet(PDF) 4 Page - STMicroelectronics