RF65 datasheet(28/72 Pages) ETC2

28 / 72 page

Page 28

RF65

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

ADVANCED COMMUNICATIONS & SENSING

DATASHEET

When the AFC is automatically triggered (AfcAutoOn = 1), the user has the option to:



Clear the former AFC correction value, if AfcAutoClearOn = 1



Start the AFC evaluation from the previously corrected frequency. This may be useful in systems in which the LO keeps

on drifting in the

“same direction”. Ageing compensation is a good example.

The RF65 offers an alternate receiver bandwidth setting during the AFC phase, to accommodate large LO drifts. If the

user considers that the received signal may be out of the receiver bandwidth, a higher channel filter bandwidth can be

programmed in RegAfcBw, at the expense of the receiver noise floor, which will impact upon sensitivity.

3.4.17. Optimized Setup for Low Modulation Index Systems



For wide band systems, where AFC is usually not required (XTAL inaccuracies do not typically impact the sensitivity), it

is recommended to offset the LO frequency of the receiver to avoid desensitization. This can be simply done by

modifying Frf in RegFrfLsb. A good rule of thumb is to offset the receiver

‟s LO by 10% of the expected transmitter

frequency deviation.



For narrow band systems, it is recommended to perform AFC. The RF65 has a dedicated AFC, enabled when

AfcLowBetaOn in RegAfcCtrl is set to 1. A frequency offset, programmable through LowBetaAfcOffset in RegTestAfc, is

added and is calculated as follows:

Offset = LowBetaAfcOffset x 488 Hz

The user should ensure that the programmed offset exceeds the DC canceller

‟s cutoff frequency, set through DccFreqAfc

in RegAfcBw.

RX & TX

FeiValue

Standard AFC

AfcLowBetaOn = 0

AfcValue

TX RX

FeiValue

Optimized AFC

AfcLowBetaOn = 1

AfcValue

LowBetaAfcOffset

Before AFC

After AFC

Figure 12. Optimized Afc (AfcLowBetaOn=1)

As shown on Figure 12, a standard AFC sequence uses the result of the FEI to correct the LO frequency and align both

local oscillators. When the optimized AFC is enabled (AfcLowBetaOn=1), the receiver

‟s LO is corrected by “FeiValue +

LowBetaAfcOffset

”.

When the optimized AFC routine is enabled, the receiver startup time can be computed as follows (refer to section 4.2.1):

TS_RE_AGC&AFC (optimized AFC) = Tana + 4.Tcf + 4.Tdcc + 3.Trssi + 2.Tafc + 2.Tpllafc

RF65 Datasheet(PDF) 28 Page - List of Unclassifed Manufacturers

RF65 Datasheet(HTML) 28 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

Datasheet Download

Link URL