General Description
The IDT8T49N445I is a quad PLL with FemtoClock® NG technology.
The IDT8T49N445I integrates low phase noise Frequency
Translation / Synthesizer and jitter attenuation. It includes alarm and
monitoring functions suitable for networking and communications
applications. The device has four fully independent PLLs, each PLL
is able to generate any output frequency in the 0.98MHz - 312.5MHz
range and most output frequencies in the 312.5MHz - 1,300MHz
range (see Table 3 for details). A wide range of input reference
clocks may be used as the source for the output frequency.
Each PLL of IDT8T49N445I has three operating modes to support a
very broad spectrum of applications:
1) Frequency Synthesizer
• Synthesizes output frequencies from an external reference
clock REFCLK.
• Fractional feedback division is used, so there are no
requirements for any specific input reference clock frequency to
produce the desired output frequency with a high degree of
accuracy.
2) High-Bandwidth Frequency Translator
• Applications: PCI Express, Computing, General Purpose
• Translates any input clock in the 16MHz - 710MHz frequency
range into any supported output frequency.
• This mode has a high PLL loop bandwidth in order to track input
reference changes, such as Spread-Spectrum Clock
modulation.
3) Low-Bandwidth Frequency Translator
• Applications: Networking & Communications.
• Translates any input clock in the 8kHz -710MHz frequency
range into any supported output frequency.
• This mode supports PLL loop bandwidths in the 10Hz - 580Hz
range and makes use of an external reference clock REFCLK
to provide significant jitter attenuation.

Features
• Fourth generation FemtoClock® NG technology
• Four fully independent PLLs
• Universal Frequency Translator™ Frequency Synthesizer and
Jitter attenuator
• Output is programmable as LVPECL or LVDS
• Programmable output frequency: 0.98MHz up to 1,300MHz
• Differential inputs support the following input types:
LVPECL, LVDS, LVHSTL, HCSL
• Input frequency range: 8kHz - 710MHz (Low-Bandwidth mode)
• Input frequency range: 16kHz - 710MHz (High-Bandwidth mode)
• REFCLK frequency range: 16MHz - 40MHz
• Input clock monitor on each PLL will smoothly switch between
redundant input references
• Operation reference frequency range: 16MHz - 40MHz
• Input clock monitor and alarm
• Factory-set register configuration for power-up default state
• Power-up default configuration
• Configuration customized via One-Time Programmable ROM
• Settings may be overwritten after power-up via I2C
• I
2C Serial interface for register programming
• RMS phase jitter at 161.1328125MHz, using 40MHz REFCLK
(12kHz - 20MHz): 465fs (typical), Low Bandwidth Mode (FracN)
• RMS phase jitter at 400MHz, using 40MHz REFCLK
(12kHz - 20MHz): 333fs (typical), synthesizer Mode (integer FB)
• Full 2.5V supply mode
• -40°C to 85°C ambient operating temperature
• 10mm X 10mm CABGA
• Lead-free (RoHS 6) packaging