SM320VC33 datasheet(33/54 Pages) TI

33 / 54 page

SM320VC33, SMJ320VC33

DIGITAL SIGNAL PROCESSOR

SGUS034E - FEBRUARY 2001 - REVISED OCTOBER 2002

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251-1443

XF0 timing when executing STFI and STII†

The following table defines the timing parameters for the XF0 pin during execution of STFI or STII.

switching characteristics over recommended operating conditions for XF0 when executing STFI

or STII (see Figure 22)

PARAMETER

MIN

MAX

UNIT

td(H3H-XF0H)

Delay time, H3 high to XF0 high†

† XF0 is always set high at the beginning of the execute phase of the interlock-store instruction. When no pipeline conflicts occur, the address of

the store is also driven at the beginning of the execute phase of the interlock-store instruction. However, if a pipeline conflict prevents the store

from executing, the address of the store will not be driven until the store can execute.

PAGEx, STRB

R/W

A[23:0]

D[31:0]

RDY

XF0

Fetch

STFI or STII

Read

Execute

Decode

td(H3H-XF0H)

Figure 22. Timing for XF0 When Executing an STFI or STII

SM320VC33 Datasheet(PDF) 33 Page - Texas Instruments