MSP430 datasheet(64/96 Pages) TI2

64 / 96 page

MSP430G2533, MSP430G2433, MSP430G2333, MSP430G2233

MSP430G2403, MSP430G2303, MSP430G2203

SLAS734G – APRIL 2011 – REVISED APRIL 2016

www.ti.com

Submit Documentation Feedback

Product Folder Links: MSP430G2533 MSP430G2433 MSP430G2333 MSP430G2233 MSP430G2403 MSP430G2303

MSP430G2203

Device and Documentation Support

7.1

Getting Started and Next Steps

For more information on the MSP430™ family of devices and the tools and libraries that are available to

help with your development, visit the Getting Started page.

7.2

Device Nomenclature

To designate the stages in the product development cycle, TI assigns prefixes to the part numbers of all

MSP430 MCU devices and support tools. Each MSP430 MCU commercial family member has one of

three prefixes: MSP, PMS, or XMS (for example, MSP430F5438A). TI recommends two of three possible

prefix designators for its support tools: MSP and MSPX. These prefixes represent evolutionary stages of

product development from engineering prototypes (with XMS for devices and MSPX for tools) through fully

qualified production devices and tools (with MSP for devices and MSP for tools).

Device development evolutionary flow:

XMS – Experimental device that is not necessarily representative of the electrical specifications for the

final device

PMS – Final silicon die that conforms to the electrical specifications for the device but has not completed

quality and reliability verification

MSP – Fully qualified production device

Support tool development evolutionary flow:

MSPX – Development-support product that has not yet completed TI's internal qualification testing.

MSP – Fully-qualified development-support product

XMS and PMS devices and MSPX development-support tools are shipped against the following

disclaimer:

"Developmental product is intended for internal evaluation purposes."

MSP devices and MSP development-support tools have been characterized fully, and the quality and

reliability of the device have been demonstrated fully. TI's standard warranty applies.

Predictions show that prototype devices (XMS and PMS) have a greater failure rate than the standard

production devices. TI recommends that these devices not be used in any production system because

their expected end-use failure rate still is undefined. Only qualified production devices are to be used.

TI device nomenclature also includes a suffix with the device family name. This suffix indicates the

package type (for example, PZP) and temperature range (for example, T). Figure 7-1 provides a legend

for reading the complete device name for any family member.

MSP430 Datasheet(PDF) 64 Page - Texas Instruments