ML22Q533 datasheet(121/178 Pages) ROHM

121 / 178 page

FEDL22Q53X-02

ML22Q53X

 SLOOP command

・ Command

CH3

CH2

CH1

CH0

1st byte

The SLOOP command sets the repeat playback of the specified channel. Setting the CH0 to CH3 bit to 1 repeatedly plays

back the corresponding channel. This command can be input when the NCR signal of the corresponding channel is "H" level.

When repeat playback is set, playback is repeatedly performed until the repeat playback setting is canceled by the CLOOP

command or playback is stopped by the STOP command. Also, if the phrase has been edited, the edited phrase is played

repeatedly.

The channel settings are as follows:

Channeled

Description

CH0

Setting this bit to 1 repeats playback on channel 0.

CH1

Setting this bit to 1 repeats playback on channel 1.

CH2

Setting this bit to 1 repeats playback on channel 2.

CH3

Setting this bit to 1 repeats playback on channel 3.

Be sure to specify one of the channels for the channel setting (CH0-CH3).

Do not input it to "0" (all “0”) with specifying nothing. If it is input with specifying nothing (all "0"), the command is

ignored.

For the timing of the SLOOP command, refer to the "Repeat playback setting/release timing by SLOOP/CLOOP command"

in the timing chart.

121/178

ML22Q533 Datasheet(PDF) 121 Page - Rohm