HD6432147SW datasheet(219/1177 Pages) RENESAS

219 / 1177 page

Section 6 Bus Controller

Rev. 4.00 Sep 27, 2006 page 175 of 1130

REJ09B0327-0400

6.5.3

Wait Control

As with the basic bus interface, either program wait insertion or pin wait insertion using the

WAIT

pin can be used in the initial cycle (full access) of the burst ROM interface. See section 6.4.5, Wait

Control.

Wait states cannot be inserted in a burst cycle.

6.6

Idle Cycle

6.6.1

Operation

When this LSI chip accesses external space, it can insert a 1-state idle cycle (T

I) between bus

cycles when a write cycle occurs immediately after a read cycle. By inserting an idle cycle it is

possible, for example, to avoid data collisions between ROM, with a long output floating time, and

high-speed memory, I/O interfaces, and so on.

If an external write occurs after an external read while the ICIS0 bit in BCR is set to 1, an idle

cycle is inserted at the start of the write cycle. This is enabled in advanced mode and normal

mode.

Figure 6.15 shows an example of the operation in this case. In this example, bus cycle A is a read

cycle from ROM with a long output floating time, and bus cycle B is a CPU write cycle. In (a), an

idle cycle is not inserted, and a collision occurs in cycle B between the read data from ROM and

the CPU write data. In (b), an idle cycle is inserted, and a data collision is prevented.

HD6432147SW Datasheet(PDF) 219 Page - Renesas Technology Corp