LPC4350 datasheet(83/149 Pages) PHILIPS

83 / 149 page

LPC4350_30_20_10

All information provided in this document is subject to legal disclaimers.

Objective data sheet

Rev. 3.1 — 5 January 2012

83 of 149

NXP Semiconductors

LPC4350/30/20/10

32-bit ARM Cortex-M4/M0 microcontroller

velocity. In addition, a third channel, or index signal, can be used to reset the position

counter. The quadrature encoder interface decodes the digital pulses from a quadrature

encoder wheel to integrate position over time and determine direction of rotation. In

addition, the QEI can capture the velocity of the encoder wheel.

7.19.3.1

Features

• Tracks encoder position.

• Increments/decrements depending on direction.

• Programmable for 2 or 4 position counting.

• Velocity capture using built-in timer.

• Velocity compare function with “less than” interrupt.

• Uses 32-bit registers for position and velocity.

• Three position compare registers with interrupts.

• Index counter for revolution counting.

• Index compare register with interrupts.

• Can combine index and position interrupts to produce an interrupt for whole and

partial revolution displacement.

• Digital filter with programmable delays for encoder input signals.

• Can accept decoded signal inputs (clk and direction).

7.19.4 Repetitive Interrupt (RI) timer

The repetitive interrupt timer provides a free-running 32-bit counter which is compared to

a selectable value, generating an interrupt when a match occurs. Any bits of the

timer/compare can be masked such that they do not contribute to the match detection.

The repetitive interrupt timer can be used to create an interrupt that repeats at

predetermined intervals.

7.19.4.1

Features

• 32-bit counter. Counter can be free-running or be reset by a generated interrupt.

• 32-bit compare value.

• 32-bit compare mask. An interrupt is generated when the counter value equals the

compare value, after masking. This allows for combinations not possible with a simple

compare.

7.19.5 Windowed WatchDog Timer (WWDT)

The purpose of the watchdog is to reset the controller if software fails to periodically

service it within a programmable time window.

7.19.5.1

Features

• Internally resets chip if not periodically reloaded during the programmable time-out

period.

• Optional windowed operation requires reload to occur between a minimum and

maximum time period, both programmable.

LPC4350 Datasheet(PDF) 83 Page - NXP Semiconductors

LPC4350 Datasheet(HTML) 83 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL