UM0272 datasheet(25/40 Pages) STMICROELECTRONICS

25 / 40 page

UM0272

Menus

25/40

Figure 19.

Zone setting menus

Description

The Zone description is 16 characters long and is displayed on the System Status

(Section 5.4: System status) and Log Event (see Section 5.5: Log event) menus. This

displays a more significant name rather than a number. To change the description, press

ENT, enter the new text and press ENT again to store the new description.

Status

The Status sub-menu adds or removes the selected zone from the control flow. Once

disabled, the zone is no longer under control, even if included in an enabled partition.

This option is used for disabling the zone if it is not used, if a sensor connected on it is

broken (waiting for a replacement) or to temporarily disable the zone without losing any

settings. Press ENT to switch between the two possible values (enabled/disabled).

Input time

The input time is delay between the detection of an alarm condition and the triggering of the

associated outputs. Normally this time is assigned to zones that protect the area (and the

UM0272 Datasheet(PDF) 25 Page - STMicroelectronics