June 2009

Doc ID 14320 Rev 3

5/23

UM0501

User manual

STM8/128-EVAL demonstration firmware

Introduction

This document describes the demonstration firmware running on the STM8/128-EVAL

evaluation board. You can use it to evaluate the capabilities of the microcontroller and the

on-board peripherals.

The evaluation board is delivered with the demonstration firmware stored in the Flash

program memory of the microcontroller.

The firmware is based on the STM8S firmware library, and provides an example of how to

use this library. It is divided into various smaller demonstration applications (demos).

In case the STM8/128-EVAL evaluation board is not factory-programmed or the

demonstration application has been erased, you can reprogram the demonstration firmware

into the STM8S2xx Flash memory by following the instructions provided in Section 3.

For more information about the evaluation board itself, please read the evaluation board

user manual.

Note:

To run some of the demonstration applications, the option byte must be configured

accordingly. Refer to Section 2.10: BEEPER demo.

www.st.com