USB-KW019032 Freescale USB Dongle Development Board , User’s Guide, Rev. 0, 10/2015

2

Freescale Semiconductor, Inc.

Safety information

2

Safety information

2.1

FCC guidelines

This equipment is to be used by developers for evaluation purposes only, and it must not be incorporated

into any other device or system. This device is not to be sold to the general public. Integrators will be

responsible for reevaluating the end product (including the transmitter), and obtaining a separate FCC

authorization.

The FCC approval of this device only covers the original configuration of this device (as supplied).

Any modifications to this product (including changes shown in this manual) violate the rules of the Federal

Communications Commission and Industry Canada, and make operation of the product unlawful.

2.1.1

Labeling

The FCC labels are located on the back of the board.

2.1.2

Operating conditions

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

•

This device must not cause harmful interference

•

This device must accept any interference received, including interference that can cause undesired

operation

2.1.3

Exposure limits

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

The antenna(s) used for this equipment must be installed to provide a separation distance of at least

eight inches (20 cm) from people.

2.1.4

Antenna restrictions

An intentional radiator is designed to ensure that no antenna other than that furnished by the responsible

party is used with the device. The use of a permanently attached antenna (or of an antenna that uses unique

coupling to the intentional radiator) is considered sufficient to comply with the provisions of this section.

The manufacturer can design the unit so that a broken antenna can be replaced by the user, but the use of

a standard antenna jack or electrical connector is prohibited. This requirement does not apply to carrier

current devices or to devices operated under the provisions of sections 15.211, 15.213, 15.217, 15.219, or

15.221 of the IEEE 802.15.4 standard. Further on, this requirement does not apply to intentional radiators

that must be professionally installed, such as perimeter-protection systems and some field-disturbance

sensors, or to other intentional radiators, which, in accordance with section 15.31(d), must be measured at

the installation site. However, the installer is responsible for ensuring that a proper antenna is employed,

so that the limits in this part are not exceeded.