LM4917MTSLASHNOPB datasheet(4/25 Pages) TI1

4 / 25 page

LM4917

SNAS238G – AUGUST 2004 – REVISED MAY 2013

www.ti.com

This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with

appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.

ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more

susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.

Absolute Maximum Ratings

(1)

Supply Voltage

4.0V

Storage Temperature

−65°C to +150°C

Input Voltage

-0.3V to VDD + 0.3V

Power Dissipation(2)

Internally Limited

ESD Susceptibility(3)

2000V

ESD Susceptibility(4)

200V

Junction Temperature

150°C

θJC (TSSOP)

40°C/W

Thermal Resistance

θJA (TSSOP)

109°C/W

(1)

Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for

which the device is functional but do not specify performance limits. Electrical Characteristics state DC and AC electrical specifications

under particular test conditions that ensure specific performance limits. This assumes that the device is within the Operating Ratings.

Specifications are not ensured for parameters where no limit is given; however, the typical value is a good indication of device

performance.

(2)

The maximum power dissipation must be derated at elevated temperatures and is dictated by TJMAX, θJA, and the ambient temperature,

TA. The maximum allowable power dissipation is PDMAX = (TJMAX - TA) / θJA or the number given in Absolute Maximum Ratings,

whichever is lower. For the LM4917, see power de-rating currents for more information.

(3)

Human body model, 100pF discharged through a 1.5k

Ω resistor.

(4)

Machine Model, 220pF-240pF discharged through all pins.

Operating Ratings

TMIN ≤ TA ≤ TMAX

−40°C ≤ TA ≤ 85°C

Temperature Range

Supply Voltage (VDD)

(1)

1.4V

≤ VCC ≤ 3.6V

(1)

If the product is in shutdown mode and VDD exceeds 3.6V (to a max of 4V VDD) then most of the excess current will flow through the

ESD protection circuits. If the source impedance limits the current to a max of 10mA, then the part will be protected. If the part is

enabled when VDD is above 4V circuit performance will be curtailed or the part may be permanently damaged.

Submit Documentation Feedback

Product Folder Links: LM4917

LM4917MT/NOPB Datasheet(PDF) 4 Page - Texas Instruments

LM4917MT/NOPB Datasheet(HTML) 4 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Datasheet Download

Link URL