CC2650MODAMOHT datasheet(25/40 Pages) TI1

25 / 40 page

CC2650MODA

www.ti.com

SWRS187A – AUGUST 2016 – REVISED AUGUST 2016

Submit Documentation Feedback

Product Folder Links: CC2650MODA

Detailed Description

6.5

Sensor Controller

The Sensor Controller contains circuitry that can be selectively enabled in standby mode. The peripherals

in this domain may be controlled by the Sensor Controller Engine, which is a proprietary power-optimized

CPU. This CPU can read and monitor sensors or perform other tasks autonomously, thereby significantly

reducing power consumption and offloading the main CM3 CPU.

The Sensor Controller is set up using a PC-based configuration tool, called Sensor Controller Studio, and

typical use cases may be (but are not limited to):

•

Analog sensors using integrated ADC

•

Digital sensors using GPIOs and bit-banged I2C or SPI

•

UART communication for sensor reading or debugging

•

Capacitive sensing

•

Waveform generation

•

Pulse counting

•

Keyboard scan

•

Quadrature decoder for polling rotation sensors

•

Oscillator calibration

The peripherals in the Sensor Controller include the following:

•

The low-power clocked comparator can be used to wake the device from any state in which the

comparator is active. A configurable internal reference can be used with the comparator. The output of

the comparator can also be used to trigger an interrupt or the ADC.

•

Capacitive sensing functionality is implemented through the use of a constant current source, a time-

to-digital converter, and a comparator. The continuous time comparator in this block can also be used

as a higher-accuracy alternative to the low-power clocked comparator. The Sensor Controller will take

care of baseline tracking, hysteresis, filtering and other related functions.

•

The ADC is a 12-bit, 200-ksamples/s ADC with eight inputs and a built-in voltage reference. The ADC

can be triggered by many different sources, including timers, I/O pins, software, the analog

comparator, and the RTC.

•

The Sensor Controller also includes a SPI/I2C digital interface.

•

The analog modules can be connected to up to eight different GPIOs.

The peripherals in the Sensor Controller can also be controlled from the main application processor.

Table 6-1 lists the GPIOs that are connected to the Sensor Controller.

CC2650MODAMOHT Datasheet(PDF) 25 Page - Texas Instruments

CC2650MODAMOHT Datasheet(HTML) 25 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Download

Link URL