DS2148 datasheet(2/75 Pages) DALLAS

2 / 75 page

DS2148/Q48

2 of 75

DESCRIPTION

The DS2148 is a complete selectable E1 or T1 Line Interface Unit (LIU) for short- and long-haul

applications. Throughout the data sheet, J1 is represented wherever T1 exists. Receive sensitivity adjusts

automatically to the incoming signal and can be programmed for 0dB to 12dB or 0dB to 43dB for E1

applications and 0dB to 30dB or 0dB to 36dB for T1 applications. The device can generate the necessary

G.703 E1 waveshapes in 75Ω or 120Ω applications and DSX-1 line build outs or CSU line build outs of

0dB, -7.5dB, -15dB, and -22.5dB for T1 applications. The crystal-less onboard jitter attenuator requires

only a 2.048MHz MCLK for both E1 and T1 applications (with the option of using a 1.544MHz MCLK

in T1 applications). The jitter attenuator FIFO is selectable to either 32 bits or 128 bits in depth and can

be placed in either the transmit or receive data paths. An X 2.048MHz output clock synthesized to RCLK

is available for use as a backplane system clock (where n = 1, 2, 4, or 8). The DS2148 has diagnostic

capabilities such as loopbacks and PRBS pattern generation/detection. 16-bit loop-up and loop-down

codes can be generated and detected. The device can be controlled via an 8-bit parallel muxed or

nonmuxed port, serial port or used in hardware mode. The device fully meets all of the latest E1 and T1

specifications including ANSI T1.403-1999, ANSI T1.408, AT&T TR 62411, ITU G.703, G.704, G.706,

G.736, G.775, G.823, I.431, O.151, O.161, ETSI ETS 300 166, JTG.703, JTI.431, JJ-20.1, TBR12,

TBR13, and CTR4.

DS2148 Datasheet(PDF) 2 Page - Dallas Semiconductor