RT3607CE datasheet(5/69 Pages) RICHTEK

5 / 69 page

RT3607CE

DS3607CE-01 June 2016

www.richtek.com

is a registered trademark of Richtek Technology Corporation.

Operation

The RT3607CE adopts G-NAVPTM (Green Native AVP)

which is Richtek's proprietary topology derived from finite

DC gain of EA amplifier with current mode control, making

it easy to set the droop to meet all Intel CPU requirements

of AVP (Adaptive Voltage Positioning).

The G-NAVPTM controller is one type of current mode

constant on-time control with DC offset cancellation. The

approach can not only improve DC offset problem for

increasing system accuracy but also provide fast transient

response. When current feedback signal reaches COMP

signal, the RT3607CE generates an on-time width to

achieve PWM modulation.

TON GEN/Driver Interface

Generate the PWM1 to PWM4 sequentially according to

the phase control signal from the Loop Control/Protection

Logic. Pulse width is determined by current balance result

and TONSET pin setting. Once quick response mechanism

is triggered, VR will allow all PWM to turn on at the same

time. PWM status is also controlled by Protection Logic.

Different protections may cause different PWM status

(Both High-Z or LG turn-on).

SVID Interface/Configuration Registers/Control

Logic

The interface receives the SVIDsignal from CPU and sends

the relative signals to Loop Control/Protection Logic for

loop control to execute the action by CPU. The registers

save the pin setting data from ADC output. The Control

Logic controls the ADC timing, generates the digital code

of the VID for VSEN voltage.

Loop Control/Protection Logic

It controls the power on sequence, the protection behavior,

and the operational phase number.

MUX and ADC

The MUX supports the inputs from SET1, SET2, SET3,

SETA1, SETA2, IMONI_M, IMONI_A, TSEN or TSENA.

The ADC converts these analog signals to digital codes

for reporting or performance adjustment.

Current Balance

Each phase current sense signal is sent to the current

balance circuit which adjusts the on-time of each phase

to optimize current sharing.

Offset Cancellation

Cancel the current/voltage ripple issue to get the accurate

VSEN.

UVLO

Detect the DVD and VCC voltage and issue POR signal as

they are high enough.

DAC

Generate an analog signal according to the digital code

generated by Control Logic.

Soft-Start & Slew Rate Control

Control the Dynamic VID slew rate of DAC according to

the SetVID fast or SetVID slow.

Error Amp

Error amplifier generates COMP/COMPA signal by the

difference between VSEN/VSENA and FB/FBA.

RSET/RSETA

The Ramp generator is designed to improve noise immunity

and reduce jitter.

PWM CMP

The PWM comparator compares COMP signal and current

feedback signal to generate a signal for TON trigger.

IMON Filter

IMON Filter is used for average sum current signal by

analog RC filter.

RT3607CE Datasheet(PDF) 5 Page - Richtek Technology Corporation

RT3607CE Datasheet(HTML) 5 Page - Richtek Technology Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69

Datasheet Download

Link URL