L9805E datasheet(70/125 Pages) STMICROELECTRONICS

70 / 125 page

On-chip peripherals

L9805E

70/125

Figure 38.

Block diagram of the Analog to Digital Converter

5.5.3

Input Selections and Sampling

The input section of the ADC includes the analog multiplexer and a buffer. The input of the

buffer is permanently connected to the multiplexer output. The buffer output is fed to the

sample and hold circuit.

The multiplexer is driven with CH1 and CH0 bit only after ADST is set. Starting from this

event, the sampler follows the selected input signal for 2.5us and then holds it for the

remaining conversion time (i.e. when the conversion is actually running).

5.5.4

Interrupt Management

If ADIE bit is set in register ADCCSR, an interrupt is generated when a conversion is

completed (i.e. when COCO is set).

The interrupt request is cleared when any of the ADC registers is accessd (either read or

write).

Enabling/disabling the interrupt generation while the conversion is running has no effect on

the current conversion. ADIE value is latched when ADST is set and this internal value holds

all the conversion time long.

5.5.5

Temperature Sensing

The AD1 input is internally connected to the output of a temperature sensing circuit.

CH0

CH1

ADST

logic

clk

8Mhz

2 Mhz

start conversion

.....

AD9

AD0

DRH

DRL

end conversion

Vin

VCC

AGND

inputs

CSR

sampling

conversion

latch

ADIE

L9805E Datasheet(PDF) 70 Page - STMicroelectronics

L9805E Datasheet(HTML) 70 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL