AT80SND1C-ROTIL datasheet(12/210 Pages) ATMEL

12 / 210 page

AT8xC51SND1C

4109E–8051–06/03

Clock Controller

The AT8xC51SND1C clock controller is based on an on-chip oscillator feeding an on-

chip Phase Lock Loop (PLL). All internal clocks to the peripherals and CPU core are

generated by this controller.

Oscillator

The AT8xC51SND1C X1 and X2 pins are the input and the output of a single-stage on-

chip inverter (see Figure 5) that can be configured with off-chip components such as a

Pierce oscillator (see Figure 6). Value of capacitors and crystal characteristics are

detailed in the section “DC Characteristics”.

The oscillator outputs three different clocks: a clock for the PLL, a clock for the CPU

core, and a clock for the peripherals as shown in Figure 5. These clocks are either

enabled or disabled, depending on the power reduction mode as detailed in the section

“Power Management” on page 46. The peripheral clock is used to generate the Timer 0,

Timer 1, MMC, ADC, SPI, and Port sampling clocks.

Figure 5. Oscillator Block Diagram and Symbol

Figure 6. Crystal Connection

X2 Feature

Unlike standard C51 products that require 12 oscillator clock periods per machine cycle,

the AT8xC51SND1C need only 6 oscillator clock periods per machine cycle. This fea-

ture called the “X2 feature” can be enabled using the X2 bit

(1) in CKCON (see Table 16)

and allows the AT8xC51SND1C to operate in 6 or 12 oscillator clock periods per

machine cycle. As shown in Figure 5, both CPU and peripheral clocks are affected by

this feature. Figure 7 shows the X2 mode switching waveforms. After reset the standard

mode is activated. In standard mode the CPU and peripheral clock frequency is the

oscillator frequency divided by 2 while in X2 mode, it is the oscillator frequency.

Note:

1. The X2 bit reset value depends on the X2B bit in the Hardware Security Byte (see

Table 22 on page 22). Using the AT89C51SND1C (Flash Version) the system can

boot either in standard or X2 mode depending on the X2B value. Using

AT83C51SND1C (ROM Version) the system always boots in standard mode. X2B bit

can be changed to X2 mode later by software.

PCON.1

IDL

PCON.0

Peripheral

CPU Core

CKCON.0

÷ 2

PER

CLOCK

Clock

Peripheral Clock Symbol

CPU

CLOCK

CPU Core Clock Symbol

OSC

CLOCK

Oscillator Clock Symbol

Oscillator

Clock

VSS

AT80SND1C-ROTIL Datasheet(PDF) 12 Page - ATMEL Corporation

AT80SND1C-ROTIL Datasheet(HTML) 12 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL