| Electronic Components Datasheet Search |
|
PIC10LF322T-EMCSQTP Datasheet(PDF) 85 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
PIC10LF322T-EMCSQTP Datasheet(HTML) 85 Page - Microchip Technology |
|
85 / 210 page ![]() 2011 Microchip Technology Inc. Preliminary DS41585A-page 85 PIC10(L)F320/322 12.0 FIXED VOLTAGE REFERENCE (FVR) The Fixed Voltage Reference, or FVR, is a stable voltage reference, independent of VDD, with 1.024V, 2.048V or 4.096V selectable output levels. The output of the FVR can be configured to supply a reference voltage to the following: • ADC input channel The FVR can be enabled by setting the FVREN bit of the FVRCON register. 12.1 Independent Gain Amplifiers The output of the FVR supplied to the ADC is routed through an independent programmable gain amplifier. The amplifier can be configured to amplify the reference voltage by 1x, 2x or 4x, to produce the three possible voltage levels. The ADFVR<1:0> bits of the FVRCON register are used to enable and configure the gain amplifier settings for the reference supplied to the ADC module. Refer- ence Section 15.0 “Analog-to-Digital Converter (ADC) Module” for additional information. 12.2 FVR Stabilization Period When the Fixed Voltage Reference module is enabled, it requires time for the reference and amplifier circuits to stabilize. Once the circuits stabilize and are ready for use, the FVRRDY bit of the FVRCON register will be set. See Section 24.0 “Electrical Specifications” for the minimum delay requirement. FIGURE 12-1: VOLTAGE REFERENCE BLOCK DIAGRAM FVR (To ADC Module) x1 x2 x4 + - 1.024V Fixed Reference FVREN FVRRDY 2 ADFVR<1:0> Any peripheral requiring the Fixed Reference (See Table 12-1) TABLE 12-1: PERIPHERALS REQUIRING THE FIXED VOLTAGE REFERENCE (FVR) Peripheral Conditions Description HFINTOSC FOSC = 1 EC on CLKIN pin. BOR BOREN<1:0> = 11 BOR always enabled. BOREN<1:0> = 10 and BORFS = 1 BOR disabled in Sleep mode, BOR Fast Start enabled. BOREN<1:0> = 01 and BORFS = 1 BOR under software control, BOR Fast Start enabled. IVR All PIC10F320/322 devices, when VREGPM1 = 1 and not in Sleep The device runs off of the Power-Save mode regulator when in Sleep mode. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |